Victony AC1200 extender manual setup

Without a question, access point mode is quicker than range extender mode. You should install an Ethernet wire in your walls or use one that is 20 to 30 feet long. Before we start, make sure the devices are on and in Access Point status.


We'll go into great depth about the Victony AC1200 Extender Setup in this article. We'll start by looking at the Victony dual-band AC1200 wireless extender, which has four external antennas and provides great Wi-Fi coverage at home or at work.

It is not advised to use Bluetooth-enabled devices like cordless phones, ovens, and baby monitors. The bulk of expander devices on the market are compatible with it because it supports IEEe802.11a/ac/n/g/b standards. Because it is a plug-in and supports WPS, it starts up fast.

Wps Setup for victony ac1200 extender 

  • Connect the Victony AC1200 extender device using WPS starting in the same area.
  • After the power Light on the AC1200 has been stable for a few seconds, press and hold the WPS button for two seconds.
  • Within 10 to 15 seconds, the LED lights on both devices should start to blink, signifying a good setup.
  • Thus, WPS LEDs for the Victony wa1200 would be full green.
  • If this doesn't work, keep in mind to restart the extender and attempt again.
  • After then, the extender can be removed and deployed, for instance, anywhere inside the router's coverage area.
  • The passcode you use for your Wi-Fi extender is located in the SSID EXT List.


Note:- If you need any help regarding your victony wifi extender so contact our technician or visit the official website that is ap.setup.


Victony ac1200 extender Setup with a web browser


  • The extender should be put in the centre of the router in the clear space first.
  • Ensure that your network is sending at least 50% of the data to the extender device.
  • After powering it on, place the Victony AC1200 extender in "steady state".
  • Hold on for a brief period of time until you see the power LED turn brilliant green.
  • Then, on any of your PCs, phones, tablets, or laptops, go to the Wi-Fi settings and join to Victony's wifi name. Wireless-N or the Victory Extension will be used.
  • You will initially seem like an unprotected open network.
  • When the connection is effective, the message "No internet" will play.
  • Open the browser on your device, go to ap.setup, and input the "admin" username and password. Really, everything is small.
  • The following stage entails picking the network you want to expand, giving it a name, and then authenticating it by entering the password.
  • After all adjustments have been made, it will reboot for approximately 60 seconds before your Computers can be added.
  • The Victony AC1200 repeater network, which should be available in your Wi-Fi list, is where you should connect your devices (SSID EXT).


Victony AC1200 wifi extender setup as an repeater Mode


  • First, an electrical outlet must be used to bring in the Victony extender. You should put it near your current Wi-Fi router, as advised.
  • Activate the device.
  • Press and hold the WPS button on the extender for about 2 seconds.
  • Repeat step 3 on the present router and observe how the two devices connect.
  • Once the two devices are linked, unplug the extender and place it in the empty space.
  • Sometimes resetting the router or extender resolves communication issues. To guarantee constant communication, keep the extender away from big equipment like the fridge and cooling systems.